Original Size Sensor; Contact Sensor Hp Sensor; Removing The Original Sensor (Vertical Scan Direction) - Canon iR2030 Series Service Manual

4) Detach the right cover (upper).
5) Detach the left cover (rear).
6) Open the copyboard cover (or ADF).
7) Detach the small cover.
8) Disconnect the ground cable of the ADF harness.
9) Remove the ADF harness.
10) Detach the reader rear cover.
11) Disconnect the two connectors [1], and then remove the screw [2].
12) Remove the reusable band [3], and then remove the harness [4] from the
sensor mount.
13) Remove the sensor mount [5].
14) Remove the sensor from the sensor mount.
[5]
[2]

4.4.6 Contact Sensor HP Sensor

4.4.6.1 Removing the Contact Sensor HP Sensor
iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i
1) Open the copyboard cover (or ADF).
2) Remove the copyboard glass [3].
3) Remove the ADF reading glass.
4) Pull the drive belt (front) [1] in the direction of the arrow to move he con-
tact sensor [2] to the center.
5) Remove the contact sensor [3] together with the mount.
- Screw[4], 2 pcs
6) Remove the contact sensor HP sensor.
[4]
[1] [4]
[3]
F-4-48
[1] [2]
[3]
F-4-49

4.4.7 Original Size Sensor

4.4.7.1 Removing the Original Sensor (Vertical Scan
Direction)
iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i
1) Open the copyboard cover (or ADF).
2) Remove the copyboard glass.
3) detach the cover [1].
- Screw [2], 1 pcs
4) Disconnect the flexible cable [1], and then detach the cover [2].
- Screw [3], 1 pcs
5) Pull the drive belt (front) [4] in the direction of the arrow to move the con-
tact sensor [5] to the left.
[5]
0017-8500
6) Disconnect the connector [1], and then remove the harness from the edge
saddle/clamp [2].
7) remove the original sensor (vertical scan direction) [3] together with the
mount.
- Screw [4], 3 pcs
[1] [2]
F-4-50
[2] [3] [1]
[4]
F-4-51
[2] [1]
[4]
[3]
F-4-52
Chapter 4
0017-8502
4-21