Cleaning (Touch Panel Type) - Canon iR2030 Series Service Manual

7) Place the cleaning pattern printed in step 5 in the manual feed tray with "V" up.
8) Using the left and right arrow keys, select "START CLEANING".
9) Press the OK key. Cleaning will start.

1.2.4.3 Cleaning (Touch panel type)

iR2022i / iR2025 / iR2030 / iR2018i
The parts that should be cleaned by the customer to maintain the design performance and the cleaning method are described below.
The service engineer should instruct the customer to clean the machine at regular intervals (once a month).
1. Pressure Plate
Clean the pressure plates [1] with a cloth dampened with water or neutral detergent and squeezed hard, and then wipe it with a dry soft cloth.
2. Document Glass/Glass holder (jump board)
Clean the document glass [1] with a cloth dampened with water or neutral detergent and squeezed hard, and then wipe them with a dry soft cloth.
When an ADF is installed, clean is document glass (small) [2] and glass holder [3] in the same manner.
3. Cleaning the Fixing Pressure Roller
If white streaks are seen on the printed paper, the fixing pressure roller can be dirty. If white streaks are seen on the printed paper, clean the fixing pressure roller
in the user mode.
When cleaning the fixing pressure roller, manually feed A4 paper.
MEMO:
The time required for cleaning is about 100 seconds.
F-1-25
F-1-26
[1]
[2]
[3]
F-1-27
[1]
Chapter 1
0017-5955
1-25