Chapter 2
9) Close the front cover [1].
[1]
2.2.4 Installing the Toner Bottle
iR2018 / iR2022
The image density may be slightly lower than usual on the first approx. 100
sheets printed after installation of the machine.
Therefore, perform the steps mentioned in <Going through the Developer
Idling Mode> (provided after step 6 in this section) before installing the
toner bottle.
1) Shake the toner bottle 5-6 times.
2) Open the front cover [1].
3) Insert the toner bottle.
2-8
F-2-17
F-2-18
[1]
F-2-19
F-2-20
4) While holding the toner bottle, pull the seal [1] to remove it.
0017-5526
5) Turn the toner cartridge in the direction of the arrow until it stops.
6) Close the front cover.
<Going through the Developer Idling Mode>
1) Plug the power cord into the outlet.
2) Open the front cover.
3) With the front cover open, turn on the main power switch.
4) When a message appears on the control panel display, press the following
keys to enter the service mode:
Additional functions key > 2 key > 8 key > Additional functions key
5) Select "#PRINT" using the + or - key, and then press the OK key.
6) Select "#PRINT SW" using the + or - key, and then press the OK key.
Confirm that the following message is displayed:
Message: #PRINT SW 001 00000000
7) Press the following keys and confirm the message:
# key > 1 key >1 key
Message: #PRINT SW 011 00000000
8) Position the cursor to Bit-1 (second from right) using the + or - key, and
press the 1 key, and then confirm the following message:
Message: #PRINT SW 011 00000010
9) Press the OK key. Confirm that "SW 011" changes to "SW 012".
Message: #PRINT SW 012 00000000
10) Press the Reset key to exit the service mode.
11) Close the front cover. The machine will run in the developer idling mode
for about 1 minute.
12) When the machine stops, the idling mode ends.
Install, the toner cartridge following the above-mentioned procedure.
[1]
F-2-21
F-2-22
F-2-23