Chapter 8
8.4.4 Fixing Delivery Sensor
8.4.4.1 Removing the Fixing Delivery Sensor
iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i
1) Remove the fixing unit.
2) Remove the fixing pressure release lever [2].
- Resin ring [1]
When installing the fixing pressure release lever, check that the rib [3] of the
lever is inside the pressure block [4].
3) Remove the fixing unit harness [2] from the wire saddle [1].
[2]
4) Remove the fixing paper guide [2].
- Screw [1], 1 pc.
[1]
8-12
[2]
[1]
F-8-28
[4]
[3]
F-8-29
[1]
F-8-30
[2]
F-8-31
5) Remove the right side stay [1] and left side stay [2].
- Screw [1], 2 pcs.
0017-8168
6) Disconnect the connector [1] and release the fixing DC harness [2] from
the harness guide [3]. Unhook the claw [4] and remove the sensor holder
[5].
- Screw [6], 2 pcs.
[5]
7) Release the four sensor claws [1], and then remove the fixing delivery sen-
sor [2].
[3]
[2]
[1]
F-8-32
[1]
[2]
[6]
[4]
F-8-33
[2]
F-8-34
[3]
[6]
[1]