Install The Log Assembly - Quadra-Fire SAPH-MBK-IPI Installation Manual

D. Install the Log Assembly
Log Set Assembly: LOGS-TS-IPI
Models: TIARAI-BK-IPI, TIARAI-BR-IPI, TIARAI-CES-IPI, SAPH-MBK-IPI, SAPH-D-MBK-IPI, SAPH-D-PMH-IPI, SAPH-
D-CSB-IPI, TIARAI-BK-IPIL, TIARAI-BR-IPIL, TIARAI-CES-IPIL, SAPH-MBK-IPIL, SAPH-D-MBK-IPIL, SAPH-D-PMH-
IPIL, SAPH-D-CSB-IPIL
3
Figure 1.
CAUTION: Logs are fragile, handle with care. Log #1 (2342-701): Position rear log on log shelf above pilot assembly.
Center log and pull base forward until it contacts the log tabs on the burner. See Figure 2.
Figure 3. Placement of Log #2
Log #2 (2342-702): Place log #2 into void on right side
of burner. Slide log to the left until it contacts the burner
topography. See Figure 3.
Log #3 (2342-703): Place log #3 into void on left side of
burner and slide log to the right until it contacts the burner
topography. See Figure 4.
Mineral wool (050-721): Place dime-sized pieces of mineral
wool loosely over the burner ports. only place mineral wool
on the ports that are located in front of the two front logs as
shown in Figure 5.
NOTICE: DO NOT place mineral wool over the burner ports
in the center of the burner. If center ports are covered, sooting
may occur. Adjust placement of mineral wool after fireplace
has been turned off and is cool.
51 Quadra-Fire • SAPH-MBK-IPI, SAPH-D-PMH-IPI, SAPH-D-MBK-IPI, SAPH-D-CSB-IPI Installation Manual • 2343-980_R8 • 11/14
1
2
LOG PLACEMENT INSTRUCTIONS
LOG TABS
VOID FOR LOG #3
Figure 2. Placement of Log #1
Figure 4. Placement of Log #3
PLACE MINERAL wOOL IN THESE AREAS ONLY
Figure 5. Placement of Mineral wool
VOID FOR LOG #2
2342-935