Electrical Information; General Information - Quadra-Fire SAPH-MBK-IPI Installation Manual

8

Electrical Information

A. General Information
WARNING! Risk of Shock or Explosion! DO NOT wire
110-120 VAC to the valve or to the appliance wall switch.
Incorrect wiring will damage controls.
NOTICE: This appliance must be electrically wired and
grounded in accordance with local codes or, in the absence
of local codes, with National Electric Code ANSI/NFPA
70-latest edition or the Canadian Electric Code CSA C22.1.
• Plug the cord from the appliance junction box to unswitched
110-120 VaC. this is required for proper operation of the
appliance.
• a 110-120 VaC circuit for this product must be protected with
ground-fault circuit-interrupter protection, in compliance
with the applicable electrical codes, when it is installed in
locations such as in bathrooms or near sinks.
• low voltage and 110-120 VaC voltage cannot be shared
within the same wall box.
WARNING! Risk of Shock! Plug 3-pronged (grounding)
plug directly into a properly grounded 3-pronged receptacle.
DO NOT cut or remove grounding prong from plug.
Accessories Requirements
• this appliance may be used with a wall switch, wall
mounted thermostat and/or a remote control.
Wiring for optional hearth & home technologies approved
accessories should be done now to avoid reconstruction.
Follow instructions that come with those accessories.
Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to
disconnection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105º C rated wire. Wire must have high temperature
insulation.
44 Quadra-Fire • SAPH-MBK-IPI, SAPH-D-PMH-IPI, SAPH-D-MBK-IPI, SAPH-D-CSB-IPI Installation Manual • 2343-980_R8 • 11/14