Getting Started; Design And Installation Considerations; Tools And Supplies Needed; Inspect Appliance And Components - Quadra-Fire SAPH-MBK-IPI Installation Manual

2

Getting Started

A. Design and Installation Considerations
heat & glo direct vent gas appliances are designed to
operate with all combustion air siphoned from outside of the
building and all exhaust gases expelled to the outside. No
additional outside air source is required.
Installation MUST comply with local, regional, state and
national codes and regulations. Consult insurance carrier,
local building inspector, fire officials or authorities having
jurisdiction over restrictions, installation inspection and
permits.
Before installing, determine the following:
• Where the appliance is to be installed.
• the vent system configuration to be used.
• gas supply piping requirements.
• electrical wiring requirements.
• Whether optional accessories—devices such as a fan or
remote control—are desired.
Installation and service of this appliance should be
performed by qualified personnel. hearth & home
technologies suggests NFI certified or factory trained
professionals, or technicians supervised by an NFI
certified professional (www.nficertified.org).
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified service
technician, service agency or your dealer.
B. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
tape measure Framing material
Pliers hammer
Phillips screwdriver Manometer
gloves Framing square
Voltmeter electric drill and bits (1/4 in.)
Plumb line Safety glasses
level Reciprocating saw
Flat blade screwdriver
Non-corrosive leak check solution
1/2 - 3/4 in. length, #6 or #8 Self-drilling screws
Caulking material (300ºF minimum continuous exposure
rating)
one 1/4 in. female connection (for optional fan).
6 Quadra-Fire • SAPH-MBK-IPI, SAPH-D-PMH-IPI, SAPH-D-MBK-IPI, SAPH-D-CSB-IPI Installation Manual • 2343-980_R8 • 11/14
C. Inspect Appliance and Components
• Carefully remove the appliance and components from the
packaging.
• the vent system components and optional accessories
may be shipped in separate packages.
• If packaged separately, the log set must be installed.
• Report to your dealer any parts damaged in shipment,
particularly the condition of the glass.
• Read all of the instructions before starting the
installation. Follow these instructions carefully during
the installation to ensure maximum safety and benefit.
WARNING! Risk of Fire or Explosion! Damaged parts
could impair safe operation. DO NOT install damaged,
incomplete or substitute components. Keep appliance dry.
hearth & home Technologies disclaims any responsibility for,
and the warranty will be voided by, the following actions:
• Installation and use of any damaged appliance or vent system
component.
• Modification of the appliance or vent system.
• Installation other than as instructed by hearth & home
technologies.
• Improper positioning of the gas logs or the glass door.
• Installation and/or use of any component part not approved
by hearth & home technologies.
Any such action may cause a fire hazard.
WARNING! Risk of Fire, Explosion or Electric Shock! DO
NOT use this appliance if any part has been under water.
Call a qualified service technician to inspect the appliance
and to replace any part of the control system and/or gas
control which has been under water.