Rear Vent - Horizontal Termination
No Elbow
Note: a derating orifice is required with this application and
is included in the Rear Vent Kit.
Note: all horizontal vent pipe runs must have 1/4 inch rise
per foot.
NOTICE: An SLK-SNKD is required for this vent
configuration.
Figure 4.14
Rear Vent - Horizontal Termination
One 45º Elbow
Note: a derating orifice is required with this application and
is included in the Rear Vent Kit.
Note: all horizontal vent pipe runs must have 1/4 inch rise
per foot.
NOTICE: An SLK-SNKD is required for this vent
configuration.
Figure 4.15
20
Quadra-Fire • SAPH-MBK-IPI, SAPH-D-PMH-IPI, SAPH-D-MBK-IPI, SAPH-D-CSB-IPI Installation Manual • 2343-980_R8 • 11/14
H
= 14 in. (356 mm) Maximum
1
H
1
H
= 14 in. (356 mm) Maximum
1
H
1