Optional Log Set Placement Instructions; Installing Logo - Quadra-Fire CLASSIC BAY 1200 Installation Manual

E. Optional Log Set Placement Instructions
1. Place the front log in first as shown in Figure 23.1.
Place log between fire pot and face of appliance with
charred area surrounding fire pot.
2. Set the left and right logs onto the front log, placing
the holes in the base of the left and right logs over the
locating pins in front log (See Figure 23.2). Ensure that
the charred ends are facing the fire pot.
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
LOCATING PINS
Figure 23.1
Charred Areas in the Back
Top Log, Left
Figure 23.2
NOTE: Due to the abrasive nature of a pellet appliance
fire, the logs are not covered under warranty.
Any placement variation other than shown here
can cause excessive heat and shall void the
appliance warranty.
June 4, 2019
Top Log
Right
Front Log
F. Installing Logo
1. Remove logo from packaging.
2. The logo has 2 studs on the back.
3. Install the logo on the lower left side of the center
panel by pressing the 2 studs into the already drilled
holes (See Figure 23.4).
Figure 23.3
7027-801C
CB1200 Free Standing
Install Logo
23