G Using Captured Files To Analyze Problems - Konica Minolta IP-423 Service Manual

HOME
Appendix
6.
Copy the desired capture file(s).
Enter the "bin" command to set the transfer mode to binary mode, and then enter the "get" command
to copy the captured file.
Deleting Capture Files
To delete capture files on the hard disk, use the "del" command to delete the desired files.
7.
End the FTP session.
Enter the "bye" command.
G
Using Captured Files to Analyze Problems
The data in the captured files is the raw data created by printer driver on the computer for print jobs sent from
a computer to the print controller. By comparing the print job data with the captured files, it possible to ana-
lyze problems with the I/O signals. In addition, you can use the "copy/lpr" commend to send the file to the
print controller to recreate a problem.
You can also extract the print job parameters from captured files.
Appendix-6
Remote file:
Enter the name of the file from the
list of captured file displayed after
running the "dir" command.
Local file:
Enter the destination and file
name for saving the captured file
selected as the remote file.