Konica Minolta IP-423 Service Manual page 52

HOME
Chapter 3 Field Service
3.
Press [5] (Config. Data) or [6] (NIC Config.) key, then press the [OK] key.
The list selected in the Test Print Menu is printed.
To check the version of the system software, press [5] (Config. Data) key. To check the version of the
network firmware, press [6] (NIC Config.) key.
4.
Check the firmware version number.
Look at the system software version number in the list to determine whether the firmware has been
updated or not.
Using the web utility to check the version
Use a web browser to check that the firmware has been updated successfully.
1.
Launch a web browser on the computer.
2.
Start the web utility.
After launching the web browser, enter the IP address for the network controller in the Address field as
shown below, then press the Enter key.
* The URL above is an example for when the IP address is 192.168.2.10.
3.
Check the version.
Use the web utility to check the version numbers for the firmware.
3-10
http://192.168.2.10/