G Capturing Files - Konica Minolta IP-423 Service Manual

HOME
Appendix
G
Capturing Files
You can use the [FTP Function] on the print controller to obtain captured files over the network. You can also
copy captured files at your computer in connecting a print controller hard disk directly.
What you need
• A PC that can be connected to the LAN
OS : Windows95/98/Me/NT 4.0/2000/XP
• LAN cable : 10Base-T/100Base-TX interface cross-over cable
Preparation
• Make sure that TCP/IP is enabled in the network setting for the print controller, and that an IP address has
been assigned to the network controller.
• Make sure that the PC and print controller are connected with a cross-over cable.
Operation Procedure
In the following, we use the Windows 98 as an example.
1.
Boot up MS-DOS on the PC.
Click [Start], then select [Programs]-[MS-DOS Prompt].
2.
Boot FTP from the DOS prompt.
Enter "ftp (IP address of the print controller)" after the "C:\" prompt.
The example above uses the IP address 10.11.32.133.
Appendix-4
Caution
If the print controller being used to capture files is connected to the LAN, disconnect the
cable, and use the cross-over cable to connect it directly to the PC. If the print controller
is connected via the parallel port, leave the parallel cable as it is, and connect the print
controller and PC by plugging the cross-over cable into the network connectors.