Konica Minolta IP-423 Service Manual page 58

HOME
Chapter 3 Field Service
PCI Device Table. (List of PCI devices)
Bus
00
00
00
00
00
00
00
00
00
00
Init DOS ROM. (Initialize DOS ROM area)
Init ATA. (Initialize ATA)
Test Disk Drive. (Search for and initialize hard disk drive)
Check ROM Extension. (Search ISA ROM)
Init Coprocessor. (Initialize Coprocessor)
Enable Cache Memory. (Enable the use of cache memory)
Enable NMI & Coprocessor Int (Enable .NMI. Initialize Coprocessor)
Init Time BIOS. (Initialize RTC)
Init Custom Setting. (Initial setting completation)
Boot!!! (Load and start OS)
IP-423:
=== Power On Self Test ===
Disable NMI. (Disable NMI interrupts)
Reset Coprocessor. (Reset the Coprocessor)
Disable Shadow. (Disable Shadow)
Init Cmos Memory. (Initialize the CMOS memory settings)
Test Timers. (Test the system timer)
Start Refresh DRAM. (Refresh DRAM)
Check DRAM Amount. (Check the amount of DRAM)
Test Base 64KB Memory. (Test memory below 64KB)
Clear Base 64KB Memory. (Clear the area of memory below 64KB)
Enable L1 Cache. (Enable the use of L1 cache)
Enable L2 Cache. (Enable the use of L2 cache)
Init BIOS Data Area. (Initialize the BIOS data area and memory controller)
Init Interrupt Controller. (Initialize and mask the interrupt controller)
Init Interrupt Vector Table. (Initialize the Interrupt Vector Table)
Enable Timer Interrupt. (Clear the interrupt mask of the system timer and the real time clock)
Init PCI. (Configure PCI devices)
Enable Shadow. (Enable Shadow)
Konica Corporation IP-423/IP-432 : BIOS Version xxx
Embedded BIOS (tm) Version x.x
Copyright (C) 2000 General Software, Inc.
3-16
Dev Func VendID DevID
00 00 1022 3000
13 00 4B43 5050
14 00 4B43 5859
14 01 4B43 5859
14 02 4B43 5859
14 03 4B43 5859
14 04 4B43 5859
14 05 4B43 5859
14 06 4B43 5859
14 07 4B43 5859
Class Irq
Host Bridge
Konica PCI Device 11
Konica PCI Device 12
Konica PCI Device 12
Konica PCI Device 12
Konica PCI Device 12
Konica PCI Device 12
Konica PCI Device 12
Konica PCI Device 12
Konica PCI Device 12