G Resetting The Network Controller To Factory Default - Konica Minolta IP-423 Service Manual

HOME
G
Resetting the network controller to Factory Default
You can reset all the parameters in the settings for the network controller to the factory default settings. This
can be used when the print controller is moved to a different operating environment (using NetWare file
server, IP subnet, etc.).
The setting can be reset to the factory defaults using the web utility or from the LCD operation panel on the
copier.
Resetting the settings to the factory default setting means that all information in the existing settings,
such as printer server names and IP addresses, will be lost. However, the serial number and MAC
address are hardwired on the print controller and are not lost.
Normally, all settings for the network controller can easily be reset to their factory defaults from the print con-
troller by resetting them from the network settings menu in the LCD display on the copier's operation panel. If
the settings cannot be reset this way for some reason, they can be reset using the slider switch* .
*: The SW No. for slide switch (reset switch) varies depending on the type of printer controller.
IP-422 : SW3 (System Board)
IP-423 : SW1 (Printer I/F Board)
1.
After turning the copier's main power switch OFF, remove the print controller from
the copier.
For more information, refer to the print controller Installation Procedure.
2.
Set the reset switch as illustrated below, connect the print controller to the copier,
then turn the copier's main power switch ON.
The settings for the network controller will be reset to their factory defaults in about 5 minutes.
When the settings for the network controller are reset to their factory defaults, two LEDs blink alter-
nately on the network controller.
3.
Again, turn the copier's main power switch OFF, remove the print controller, and
replace the reset switch to its original position.
4.
Connect the print controller to the copier and turn the copier's main power switch
back ON.
The copier reverts to its default settings.
Caution
• If grounding is not made securely, the board can be damaged during work.
Make sure to ground your body securely by using a wrist strap before starting to work.
• Do not change except reset switch.
Chapter 4 Troubleshooting
4-5