Checking For Successful Update - Konica Minolta IP-423 Service Manual

HOME
6.
Checking the Firmware Version.
Check that the firmware version has been updated to the new version.
Refer to "
G

Checking for Successful Update

After updating the firmware, check that the firmware version has been correctly updated. The version can be
checked in two ways, by printing the information list, or by using the web utility.
Printing the information list to check the version
1.
Press the [SCAN/PRINT] button on the operation panel.
[Printer basic mode] screen will appear.
2.
Press the [SETTING] key to let the [Main Menu] screen appear, then press the [1]
(Test Print Menu) key, and press the [OK] key.
[Test Print Menu] screen will appear.
G
Checking for Successful Update".
Caution
Limitations:
The updating of the print controller system software cannot be guaranteed
under the following conditions. Take care, since the system software may not be
correctly rewritten and, as a result, it may not be possible to operate the copier
properly.
• The copier is operating or there are certain jobs left uncompleted.
• Modes are enabled such as 25/36/47, Key Operator, Service and Interrup-
tion.
• An E or F error or a paper jam is not removed.
Chapter 3 Field Service
[NEXT] key
[PREV] key
3-9