Panasonic KX-TVP50 Installation Manual page 66

4.3 CONNECTING THE KX-TVP50 WITH THE PANASONIC KX-TD816 AND KX-TD1232
c)
Press the NEXT button (SP-PHONE).
Screen output: VM-01:#_ _ -1: 165
( _ _ = the port number you entered in program 117)
d)
Enter the extension number that you want this port to have.
(The default extension number for port 1: 165; port 2: 166)
e)
Press STORE.
f)
Repeat c, d, and e until all extension numbers are entered.
Conditions:
5.
Unplug or power down the KX-TD1232.
6.
Connect the jack assigned in Step 3 to the KX-TVP50.
7.
Connect your laptop computer to the KX-TVP50 and start your communication software
(i.e., HyperTerminal, Procomm Plus, Smartcom...).
Communication Parameters: 9600, 8 Bit, None, 1
8.
Set the DIP switch on the KX-TVP50 to position 5.
Only perform this step when initially setting up the system.
CAUTION
Set the DIP switch to position 5 will default the Voice Processing System, resulting in a loss
of all user programming, and voice messages (except User 1 and User 2 prompts).
9.
Plug in and power up the KX-TVP50 and wait approximately 3.5 min while the system
initialises.
"System Administration" Start-Up Sequence
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2.
Plug in and turn the power switch to ON on the KX-TD1232. The calls to the VPS can be
processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
• The Power Indicator light goes on.
• The Power Indicator light begins to flash.
• "Checking Flash Memory Cards." is displayed on the screen.
66
No 2 jacks on the system can have the same extension
number. If you try to enter a number that is already
assigned, you will hear an error tone. Each digital
extension connected provides 2 Voice Mail ports and
must have 2 different extension numbers assigned.
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX