Panasonic KX-TVP50 Installation Manual page 63

CAUTION
When 2 VPSs are connected to the KX-TA series, the following 2 procedures should be done
to make the VPSs work correctly.
1.
2.
KX-TA series
TEST: Press the INTERCOM button and then [107]. If the VPS
answers, you have an APT connection.
Set the DIP switch to position 0 after initialisation is complete.
The required programming is complete and the VPS and KX-TA series should be able to
communicate through Digital Integration.
When running the Quick Setup command (Section 5 CUSTOMISING THE SYSTEM) from the
VPS, the PBX transmits the station information automatically. This saves time when programming
the VPS.
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
Delete a mailbox in either VPS so that each extension has only ONE MAILBOX.
After Auto Configuration has been executed, an extension has a mailbox in both
VPS1 and VPS2. However each extension can have a maximum of 1 mailbox in
either VPS. To delete a mailbox, Type [D] (Delete) in the "Make (Make/Delete)"
field (see "Step 4 Creating Mailboxes" in 5.1.3 Starting the Quick Setup).
The extension should assign a Voice Mail extension from the VPS which contains
its mailbox as the destination for Call Forwarding and Voice Mail Transfer. DO
NOT assign a Voice Mail extension from the other VPS. For example, if jack 06
(extension 106) has its mailbox in the VPS1, assign extension 107 or 108 as the
destination, not extension 115 or 116 (see diagram below).
Change the extension numbers of both VPS port 1 and 2 for VPS2 from 107 and
108 to 115 and 116 (see "Extension Number of VPS Port 1" and "Extension
Number of VPS Port 2" in Table 69 in B7.3 PBX Interface Parameters).
Extension 106
6
7
8
15
16
4.2 CONNECTING THE KX-TVP50 WITH THE PANASONIC KX-TA series
KX-TVP50 (VPS1)
Mailbox for Extension 106
KX-TVP50 (VPS2)
Port 1
Extension 107
Port 2
Extension 108
Port 1
Extension 115
Port 2
Extension 116
63