Panasonic KX-TVP50 Installation Manual page 67

Screen output:
• The VPS tests the CPU card, the flash memory, and the ports
• Active ports are displayed on the screen.
Screen output:
Active COs: 1 2
APT Interface Connection is not Established
** OFF LINE MODE **
This message is shown when the digital (DPT) connection between the VPS and
telephone system cannot be established. This is normal. This message appears because
the PBX type for the VPS is not a KX-TD series system. Since the default PBX type is
set to the KX-TA series at the factory, this message will always appear. To change the
default, go to the System Administration Top Menu, and Type1-6-3-1. (Program -
Hardware Settings - PBX Interface Parameters - Dialing Parameters Menu). Select
"2:KXT Series" at the "1. PBX Type", and select "4:DPT" at the "2. Integration Mode".
Exit the menu by entering "\", and the following display will be shown.
Screen output:
If "DPT Interface Connection is not Established" is still shown, possible causes
are:
The cabling between the PBX
extension ports and the VPS is not 4-
wire or is improperly connected.
The PBX is a KX-TD series but does
not have the proper level of software
required to support DPT Integration.
The PBX is not programmed properly
to support DPT Integration.
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
4.3 CONNECTING THE KX-TVP50 WITH THE PANASONIC KX-TD816 AND KX-TD1232
Checking Flash Memory Cards.
Please wait...
PORT TEST...
SYSTEM SETUP
1... 2... 3...
until "1...2...3..." is displayed.
** OFF LINE MODE **
Cause
Table 16
Action
Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
Consult your dealer or use
Inband Integration under
hardware settings.
Do required integration
programming as described in
this chapter.
67