Panasonic KX-TVP50 Installation Manual page 61

8.
Set the DIP switch on the KX-TVP50 to position 5.
Only perform this step when initially setting up the system.
CAUTION
Setting the DIP switch to position 5 will default the Voice Processing System, resulting in a
loss of all user programming, and voice messages (except User 1 and User 2 prompts).
9.
Plug in and power up the KX-TVP50 and wait approximately 3.5 min while the system
initialises.
"System Administration" Start-Up Sequence
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2.
Plug in and turn the power switch to ON on the KX-TA series. The calls to the VPS can be
processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
• The Power Indicator light goes on.
• The Power Indicator light begins to flash.
• "Checking Flash Memory Cards." is displayed on the screen.
Screen output:
• The VPS tests the CPU card, the flash memory, and the ports
• Active ports are displayed on the screen.
Screen output:
The display will alert you if System Setup is not completed successfully.
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
Checking Flash Memory Cards.
Please wait...
PORT TEST...
SYSTEM SETUP
1... 2... 3...
until "1...2...3..." is displayed.
Active COs: 1 2
APT Interface Connection is Established
** ON LINE MODE **
4.2 CONNECTING THE KX-TVP50 WITH THE PANASONIC KX-TA series
61