Panasonic KX-TVP50 Installation Manual page 240

B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
Parameter
Call Waiting
Sequence
Release
Sequence for
Call Waiting
Inband Signaling Parameters
These parameters are used if the PBX sends DTMF tones to the VPS to indicate the state of a
call (busy, answered, disconnected, etc.). The integration Mode must be set to "Inband." If PBX
type is set to a KX-T series telephone system, the Inband Signaling parameters will
automatically default to the proper codes.
To select Inband Signaling Parameters, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 3 - 2
The following parameters can be programmed using "0-9", " ", "#", and "A-D."
Parameter
Ringback
Busy
Reorder
DND
Answer
Forward to VM
Ringing
240
Value Range
(Default)
This sequence is carried out by the VPS when performing
(1)
call waiting if the extension being called is busy.
This sequence is performed by the VPS to release call
(F) waiting.
Value Range
(Default)
Indicates "Ringback Tone." Sent to the VPS when the
(1)
extension dialled is ringing.
Indicates "Busy Tone." Sent to the VPS when the
(2)
extension dialled is busy.
Indicates "Reorder Tone." Sent to the VPS when an
(3) invalid extension number is dialled or when inadvertently
connected to another VPS.
Indicates "Do Not Disturb Tone." Sent to the VPS if the
(4)
dialled extension has the Do Not Disturb feature enabled.
Sent to the VPS when the called extension answers the
(5)
call.
Sent to the VPS if the called extension is forwarded to a
(6) voice mail port and that voice mail port is available to
accept the call.
Table 70
Description/Function
Table 71
Description/Function
SYSTEM ADMINISTRATOR'S GUIDE