Assembling The Ac Power Adapter; Led Indicators; Mx8 System Status Led - Honeywell MX8 User Manual

Assembling the AC Power Adapter

The AC adapter 4 pin barrel connector is L-shaped and keyed to the Multi-dock power port on the Charging Multi-dock.
To apply AC power to the Charging Multi-dock follow the steps below in sequence.
1. Plug the male 3 prong AC adapter cable end of the AC power assembly into an AC power source (e.g., wall outlet).
2. Press the female end of the power cable into the male connector on the AC adapter. When AC power is being supplied
to the AC adapter, the LED on the power adapter illuminates green.
3. Line up the pins on the 4-pin barrel connector end of the cable with the pins in the power port on the Multi-dock. Push
the barrel connector into the power port until it is seated firmly.
4. External power is now being supplied to the charging Multi-dock. The charging Multi-dock is ready for use.

LED Indicators

There are two LEDs per docking bay. When the Multi-dock is connected to a power source:
1. The LED on the left, when illuminated red, indicates the MX8 is properly seated in the docking bay.
2. The LED on the right, when illuminated green, indicates the docking bay is receiving power.
When both docking bay LEDs are off, an MX8 is not docked and power is not available to the docking bay.
When all LEDs are off, power is not applied to the multi-dock.

MX8 System Status LED

The MX8 System Status LED is located at the top of the MX8 keypad.
When the LED is . . .
Blinking Red
Steady Red
Blinking Green
No Color
The Status is . . . Comment
Power Fail Connect the MX8 to external AC power to allow the internal char-
ger to charge the main battery e.g., dock in a powered multi-dock.
or
Replace the main battery with a fully charged main battery.
Main Battery Low Low Battery Warning. Replace the main battery with a fully
charged main battery.
or
Dock the MX8 in a powered multi-dock.
Display Off No user intervention required.
Good No user intervention required.
12 - 13