Honeywell MX8 User Manual page 184

UPCE1- Advanced Properties
Note: The UPCE0 and UPCE1 parameters are always set to match each other. Therefore if a change is made to
a parameter to either the EPCE0 or UPCE1 Advanced Properties that same change is automatically made
to the Advanced Properties for the other symbology.
Note: UPCE0 and UPCE1 are enabled as the same symbology at the scanner. Therefore, the only way for UPCE1
configuration to be used is if UPCE0 is disabled. When UPCE0 is disabled, it is scanned by the imager but
rejected by Data Collection Wedge.
Transmit Check Character – When enabled, transmit the check character. Default is enabled
Transmit number System Digit – When enabled, transmit the number system digit. Default is enabled.
Expand Version E – When enabled, expand version E to 12-digit UPCA format. Default is disabled.
Addenda
Read 2-Digit – When enabled, transmit the 2 digit addenda. Default is disabled.
Read 5-Digit – When enable, transmit the 5 digit addenda. Default is disabled.
Required – When enabled, only transmit bar codes with a 2 or 5 digit addenda. Default is enabled.
Insert Separator – When enabled, insert a space between the code and addenda. Default is disabled.
8 - 30