Using Hsm Connect - Honeywell MX8 User Manual

Using HSM Connect

1. If an ActiveSync connection has not been established, connect the MX8 to the PC.
2. Double-click the HSMConnect icon that was created on the desktop.
3. HSM Connect launches.
4. Click the OK button to dismiss the About CERDisp dialog box on the desktop by clicking the OK button in the HSM
Connect window on the PC desktop. The dialog box automatically times out and disappears after approximately 30
seconds.
5. The MX8 can now be configured from the HSMConnect window. Input from the PC's mouse and keyboard are
recognized as if they were attached to the MX8.
6. When the remote session is completed, terminate the HSMConnect program by selecting File > Exit or clicking on the X
in the upper right hand corner to close the application, then disconnect the ActiveSync cable.
Note: After using HSM Connect, the MX8 cannot go into Suspend mode until after a warmboot. If using Power Management
on a MX8, always warmboot the MX8 when finished using HSM Connect.
5 - 70