Notification Tab; Vibration - Honeywell MX8 User Manual

Notification Tab

Setting
Enable Internal Scanner Sound
Good Scan Vibration
Bad Scan Vibration
This panel toggles internal scanner sounds on and off. Internal scanner sound, by default, is enabled.

Vibration

Enable Good scan vibration or Bad scan vibration when a tactile response on a good scan or bad scan is desired. Scan
sounds are accompanied by a tactile response when the internal scanner Sound parameter is enabled.
Enable short, medium or long duration for each selection (good scan and bad scan).
Adjust the settings and tap ok to save the changes. The changes take effect immediately.
Since the Data Collection Wedge uses the operating system interface to sound beeps, if the volume/vibrate icon is set to
anything other than On, Wedge beeps do not sound. Wedge vibration is not affected by these settings.
Default
Enabled
Off
Off
8 - 5