Bosch Solution 64 Installer's Manual page 31

Access > Prox Reader >
Reader Options
1 Arming Allowed
2 Disarming Allowed
3 Badging Required
4 Zero Exit Time
5 Part On Badging
6 Reserved
7
Reserved
8
Reserved
Enter [MENU] + [1] + [6] + [3] and select the Reader from the
1)
list then press [OK].
2) Use the up and down arrow keys to highlight the option then
press the [ON] key to enable or the [OFF] key to disable.
 Arming Allowed
 Disarming Allowed
Badging Allowed
Press  OK ON OFF MENU
3) Repeat Step 2 until all Reader options are programmed as
required, then press [OK] to save and exit or press [MENU] to
exit without saving.
Arming Allowed
Selecting this option allows the prox reader to arm the area that it
is assigned to when a valid token is presented. The User must have
access to the Area that the Reader has been assigned to.
See MENU 1-6-1 — Reader Area Assignment
Disarming Allowed
Selecting this option allows the prox reader to disarm the area that
it is assigned when a valid token is presented. The User must have
access to the Area that the Reader has been assigned to.
See MENU 1-6-1 — Reader Area Assignment.
Badging Required
Selecting this option allows the user to unlock a door and arm an Area
from a single reader. This option is only relevant if Arming Allowed has
been selected.
When the area is disarmed, presenting the Token once will unlock the
door. Presenting the Token 3 times within 5 seconds will arm the Area.
When the area is armed, presenting the Token once will disarm the
area. Presenting the Token a second time will unlock the door.
Zero Exit Time
Selecting this option allow the User to arm the area from the reader
with no exit time.
Part On Badging
Selecting this option allows the user to arm the area using their token
in Part On and Part 2 On modes. This funtion is only available at Prox
enabled Keypads.
To Arm In All On Mode
From the disarmed state, present the token once to fully arm the area.
To Arm In Part Mode
Present the token twice within 5 seconds and the area will arm in Part
Mode.
Bosch Security Systems | 11/05 | BLCC110I
To Arm In Part Mode
Present the token three times within 5 seconds and the area will arm
MENU 1-6-3

in Part Mode 2.
Y
i
Y
N
Note
N
N
N
N
N
Solution 64 | Installer Guide | Access Programming
Part Mode 2 can only be activated if there are zone
programmed for Part Mode 2. See MENU 3-0-4 — Set Part 2
Zones.
» » E N D O F S E C T I O N « «
5-9