Output Testing - Bosch Solution 64 Installer's Manual

Solution 64 | Installer Guide | Output Programming
O utput Test in g
Outputs > Testing >
External Siren Test
This menu allows you to test the operation of any output
programmed as event type 36 (External Audible) or Event Type
39 (Fire Alarm) for 5 seconds.
1) Enter [MENU] + [4] + [9] + [0] and select the area you want to
test the external sirens in from the list then press [OK].
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
Press  OK or MENU
2) Any outputs programmed for event type 36 or 39 in the chosen
area will now operate. The keypad will display the following
during the siren test.
External Audible
Testing Press any key to
Abort
Press OK or MENU
When the siren test is complete, the keypad will display the
3)
following:
Testing Complete Press
OK to continue
Press OK or MENU
4) Press [OK] to exit.
Outputs > Testing >
Internal Bell Test
This menu allows you to test any output programmed as event
type 37 (Internal Audible) or event type 39 (Fire Alarm) for 5
seconds.
Enter [MENU] + [4] + [9] + [1] and select the area you want to
1)
test the internal sirens in from the list then press [OK].
2) Any outputs programmed for event type 37 or 39 in the chosen
area will now operate. The keypad will display the following
during the siren test.
Internal Audible
Testing Press any key to
Abort
Press OK or MENU
When the bell test is complete, the keypad will display the
3)
testing complete message.
4) Press [OK] to exit.
8-8
-
MENU 4-9-0
 
-
MENU 4-9-1
 
Outputs > Testing >
Strobe Siren Test
This menu allows you to test the any outputs programmed as
event type 48, Strobe light. This test is not timed and needs to
be manually stopped when testing is completed.
1) Enter [MENU] + [4] + [9] + [2] and select the area you want to
test the strobe lights in from the list then press [OK].
2) Any outputs programmed for event type 48 in the chosen area
will now operate. The keypad will display the following during
the siren test.
Strobe Activated. Will
Reset On Exit
Press OK or MENU
3) Check and verify that the strobe lights are working correctly
then press [OK] to end the test.
-
MENU 4-9-2
 
Bosch Security Systems | 11/05 | BLCC110I