BRP Evinrude Installation Manual page 74

OUTBOARD RIGGING
EVINRUDE E-TEC MODELS 15–30 HP
Adjust the shift cable trunnion to align with the
center of the trunnion block.
1
1. Shift linkage
2. Shift cable
Install cable retainer and screw. Tighten screw to
a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
1. Cable retainer
With remote control lever in NEUTRAL, pull firmly
on throttle cable casing to remove slack.
With engine throttle lever against stop, place the
cable trunnion into the upper anchor pocket and
72
adjust the trunnion nut so the casing fits onto the
throttle lever pin.
2
1
007215 1. Throttle lever pin
2. Trunnion nut
2
1. Throttle lever stop
IMPORTANT:
007121
WARD and pull back slowly to NEUTRAL. Make
sure the engine throttle lever is against the stop. If
not, remove slack by adjusting cable trunnion.
Install cable retainer and screw. Tighten screw to
a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
Install washers and retainer clips on shift lever
and throttle pins. Refer to Cable Retainer Clip
Installation on p. 51.
Move control handle to FOR-
2
007217
1
007216