BRP Evinrude Installation Manual page 71

3 C M
YLINDER ODELS
EMM CANbus connector cap is clipped to EMM
cooling water hose. Remove clip from cap and
install on I-Command harness connector.
1
1. Canbus harness connector
2. EMM CANbus connector cap and clip
Install clip and connector to hose.
1
1. CANbus connectors
2. EMM cooling water hose
A M
LL ODELS
Adjust harness routing as needed and secure with
tie straps.
Use an I-Command Ignition and Trim Harness to
connect the outboard to the key switch and trim/tilt
control. Seal unused SystemCheck connector
with 6-Pin Connector Seal, P/N 586076.
EVINRUDE E-TEC MODELS 40–90 HP
If connecting to an existing Deutsch-style I-Com-
mand network, connect the purple wires between
the I-Command Ignition and Trim Harness and the
I-Command Engine Interface Cable. This connec-
tion supplies power to the network when the key
switch is on. Newer, quick connect-style networks
2
do not use this connection.
1
2
3
006743
1. Trim/Tilt connector
2. I-Command Ignition connector
3. SystemCheck connector (with seal)
4. Network power supply connector
2
Route I-Command Ignition Harness through wire
channel in flywheel cover. Install electrical cover.
Make sure both harnesses are in front of the tab
and tighten with tie strap.
1
006744
2
1. Electrical cover
2. Wire channel
3. Tab
4. Tie strap
OUTBOARD RIGGING
4
006734
3
4
006737
69
3