BRP Evinrude Installation Manual page 47

15–30 HP M
ODELS
Install Lifting Tool, P/N 354717, on both sides of
the tilt tube.
1
1. Lifting tool, P/N 354717
A
WARNING
To avoid personal injury or outboard dam-
age, be sure the lifting tool is fully threaded
on both sides of the tilt tube.
Use an appropriate chain, at least 36 inches (91
cm) long with two snap hooks, each capable of lift-
ing 500 lbs. (227 kg).
Attach hooks to lifting device and attach chain to
hoist.
A
WARNING
Use this tool for horizontal lifting of 30 HP
and smaller Evinrude E-TEC models ONLY.
DO NOT use this tool to lift outboards
larger than 30 HP Evinrude E-TEC models.
To avoid personal injury and boat or out-
board damage, DO NOT use this tool to
install or remove outboard from transom
as outboard can unexpectedly tip.
Lift the engine out of the carton.
1
1. Lifting tool, P/N 354717
Remove upper motor cover.
007122
Place clean pad or cardboard on the floor.
Lower outboard onto the pad. Use hoist to care-
fully roll the outboard onto its port side.
To avoid damage to the outboard, DO NOT
allow the outboard to fall unrestrained.
Remove chain from lifting tool.
Remove lifting tool from outboard.
OUTBOARD INSTALLATION
LIFTING THE OUTBOARD
A
CAUTION
2
007123
007211
45