BRP Evinrude Installation Manual page 66

OUTBOARD RIGGING
EVINRUDE E-TEC 60° V MODELS 115–200 HP
Water Pressure Gauge
To display engine water pressure, install a water
pressure hose fitting in the cylinder block as
shown.
Use Pipe Sealant with Teflon on the threads of the
hose fitting. Refer to installation instructions sup-
plied with gauge.
Route the water pressure hose around the star-
board side of the powerhead along the same path
as the battery cables.
1. Water pressure hose fitting
For an I-Command water pressure display, sev-
eral water pressure sensor kits are available.
Refer to the Evinrude/Johnson Genuine Parts
and Accessories catalog.
64
To send water pressure data to the EMM, along
with an I-Command display, install a water pres-
sure transducer kit.
•
Use 50 psi
P/N 5008640 on 2012 and newer 60° V4/V6
models.
•
Use 30 psi
P/N 5008300 on 2011 and older 60° V4/V6
models.
1
1
1. Water pressure transducer
Connect the transducer lead to the engine wiring
harness connector.
004959
1
1. Water pressure transducer lead
2. Engine harness connector
Water Pressure Transducer Kit,
Water Pressure Transducer Kit,
008129
2
004962