Evinrude E-Tec Models 40-90 Hp - BRP Evinrude Installation Manual

EVINRUDE E-TEC
MODELS 40–90 HP
Cable, Hose, and Wire Routing
A
CAUTION
To prevent accidental starting while servic-
ing, disconnect the battery cables at the
battery. Twist and remove all spark plug
leads.
Refer to Control Cable Identification on p. 51.
Apply soapy water to the inside surfaces of grom-
met and install cables and fuel line as shown:
1
2
1. Throttle cable
2. Shift cable
3. Main wiring harness
4. Battery cable
5. Fuel line
Place the grommet into position in the lower
engine cover.
EVINRUDE E-TEC MODELS 40–90 HP
When grommet is in place and all cables have
been installed, tighten a tie strap around the out-
side of the grommet to form a watertight seal
around the cables.
NOTICE
After installation, make sure there
is enough clearance for all cables to avoid
binding or chafing through all engine steering
and tilting angles.
Control Cable Installation
Refer to Control Cable Identification on p. 51.
Remove cable retainer from anchor block. Apply
Triple-Guard grease to both anchor block pockets.
3
1
4
5
1. Cable retainer
001998
IMPORTANT:
and shift lever pins until all cables, wires, and
hoses have been routed and grommet has been
installed in the lower engine cover.
Make sure the remote control is in NEUTRAL, and
throttle is in the IDLE position.
Pull firmly on shift cable casing to remove slack.
With outboard in NEUTRAL, place the cable trun-
002104
OUTBOARD RIGGING
DO NOT secure cables to throttle
3
002099
65