BRP Evinrude Installation Manual page 65

Use Evinrude Diagnostics software to adjust net-
work settings in the EMM. From the Settings
screen, select Engine Options.
Engine Options Screen
ICON Network Connections
If the outboard is equipped for an Evinrude ICON
control system, connect the outboard to the net-
work as follows.
Refer to Evinrude ICON / I-Command Harness
Connections on p. 14.
Connect the buss cable from the rear network hub
to the outboard's network harness.
1. ICON network connector
IMPORTANT:
Do not force connectors or lock-
ing rings. Properly aligned connectors should
assemble easily.
Do not use Electrical Grease on ICON buss cable
connectors.
EVINRUDE E-TEC 60° V MODELS 115–200 HP
To assemble the connectors:
•
Use the large tabs and small tabs to carefully
align buss cable connectors.
•
Carefully align pins and sockets of connectors.
Do NOT force connectors together.
•
Tighten locking rings of buss connectors finger
tight. Do NOT use locking rings to force connec-
tors together.
008563
1. Large tabs
2. Small tabs
Do not rotate connectors until they align. This
could result in a mismatched connection. It is pos-
sible for each pin to enter a socket even if the tabs
are misaligned. Look at the tabs to ensure con-
nector alignment prior to making the connection.
Engine Monitor information is distributed to an
ICON or I-Command network through the ICON
gateway module. Refer to the I-Command Digital
Network Guide, P/N 355008.
The ICON Harness and Relay Kit, P/N 765296,
must be used to provide power to boat accesso-
ries that require switched B+. This kit is used in
place of connecting accessories to the "A" termi-
nal of the key switch. Accessories connected to
1
the accessory power relay should not exceed 7
amps.
NOTICE
Do not connect boat accessories to
the key switch of an ICON system. Connecting
008157
accessories to the key switch can cause low
current, resulting in erratic operation of the
remote control system.
For more information, refer to the Evinrude ICON
Remote Control System Installation Guide,
P/N 764952.
OUTBOARD RIGGING
1
2
007883
63
3