BRP Evinrude Installation Manual page 63

Connect outboard main wire harness to boat wire
harness. Secure connectors in brackets.
1. Harness connections
Route oil tank sending unit harness around the
front to the port side. Secure all cables with tie
straps.
1. Low oil sender connection
2. Tie straps
Secure all cables with tie-straps.
1. Anchor points
EVINRUDE E-TEC 60° V MODELS 115–200 HP
NOTICE
BE SURE all harnesses and wires
are not pinched, cannot contact flywheel, and
do not interfere with moving throttle or shift
linkages.
Replace flywheel/harness connector cover.
I-Command Network Connections
1
If the outboard will be used with I-Command, or
other NMEA 2000 compliant CANbus instruments,
use the following connections to supply informa-
tion to the network:
If using an Evinrude ICON control system, the I-
004951
Command Engine Interface Cable, Power Supply
Kit, and Ignition and Trim Harness are not
required. Connect
directly to the ICON gateway module. Refer to
Evinrude ICON / I-Command Harness Connec-
tions on p. 14.
If using a mechanical control system, connect the
I-Command Engine Interface Cable to the EMM
1
CANbus connector.
2
004952
1. EMM CANbus connector
1
005270
OUTBOARD RIGGING
the I-Command network
005267
3
1
61