Table of Contents
Advertisement
OUTBOARD RIGGING
COMMON PRACTICES –
ALL MODELS
Control Cable Identification
IMPORTANT:
Identify control cable function
before rigging outboard.
Identify each control cable:
•
Put the control handle into NEUTRAL position.
The throttle cable casing guide will retract com-
pletely and the shift cable casing guide will go to
the midpoint of its travel.
1. Shift cable casing guide extended to midpoint
2. Throttle cable casing guide retracted
Extend the control cables and lubricate them with
Triple-Guard grease.
COMMON PRACTICES – ALL MODELS
Cable Retainer Clip Installation
When installing retainer clips on control arm link-
age pins, clips should be locked and must not be
bent or deformed.
For proper installation, review the following steps:
•
Place washer on pin.
•
Position retainer clip with straight section on the
bottom and angled section on the top.
•
Use long nose pliers to insert straight section of
clip into linkage pin hole.
1
2
1. Straight section
DP0811
2. Angled section
•
Push the clip towards the hole while lifting on
the curved end with the pliers.
•
Be sure retainer clip fully engages the pin.
•
Lock the retainer by moving the angled section
behind the straight section.
Locked Retainer Clip
1. Angled section behind straight section
30501
OUTBOARD RIGGING
1
2
DP0818N
DP0817
1
DP0817A
51
3
Hide quick links:
Advertisement
Table of Contents
