Battery Installation; Battery Recommendations; Battery Connections - BRP Evinrude Installation Manual

BATTERY INSTALLATION

Each outboard requires its own starting battery.
Select a battery that meets or exceeds the mini-
mum requirements.

Battery Recommendations

Outboard Model
115–300 HP
15–90 HP
Battery Location
Proper installation will prevent battery movement
while underway.
•
Secure all batteries in protected locations
•
Place battery as close to the outboard as possi-
ble
•
Battery location must provide access for peri-
odic maintenance
•
Use battery mounting trays or battery boxes on
all battery installations
•
Connections and terminals must be covered
with an insulator
•
Battery connections must be clean and free
from corrosion
•
Read and understand the safety information
supplied with the battery before installation.
Battery Rating
675 CCA (845 MCA), or
800 CCA (1000 MCA)
below 32°F (0°C)
107 amp-hr in extreme
applications
640 CCA (800 MCA), or
800 CCA (1000 MCA)
below 32° F (0° C)
107 amp-hr in extreme
applications
BATTERY INSTALLATION

Battery Connections

A
WARNING
Keep the battery connections clean, tight,
and insulated to prevent their shorting or
arcing and causing an explosion. If the bat-
tery mounting system does not cover the
connections, install protective covers.
Check often to see that connections stay
clean and tight.
IMPORTANT:
Connect the battery positive (+)
cable to the battery positive (+) post FIRST. Con-
nect the battery negative (–) cable to the battery
negative (–) post LAST.
Install a starwasher on the threaded battery post.
Stack cables from the outboard, then cables from
accessories. Finish this connection with a hex nut.
Marine Style Battery Post
1. Starwasher
2. Hex nut
3. Terminal Insulator
NOTICE
Do not use wing nuts to fasten ANY
battery cables. Wing nuts can loosen and
cause electrical system damage not covered
under warranty.
Tighten all connections securely. Apply Triple-
Guard grease to prevent corrosion.
BOAT RIGGING
1
3
2
1
DR5103
15