Presser Feet - Husqvarna Viking Designer SE User Manual

Presser Feet

There are a number of presser feet for different
purposes supplied with your Designer SE.
Utility Foot A
Fitted on the machine upon delivery. This foot
is used mainly for straight stitching and zigzag
stitching with a stitch length longer than 1.0.
Utility Foot B
When sewing close zigzag stitches with less
than 1.0 mm stitch length, other utility stitches
or decorative stitches, use this foot. The tunnel
at the bottom of the foot is designed to feed
smoothly over the stitches.
Buttonhole Foot C
This foot has guide lines to determine
buttonhole length. The middle mark gives a 5/8''
(15 mm) buttoning edge. The two tunnels on the
bottom of the foot ensures a smooth feed over
the buttonhole columns. Finger on the back of
the foot holds cording for corded buttonhole.
Blind Hem Foot D
This foot is used for blind hem stitches. The
inner edge of this foot guides the fabric. The
right toe of the foot is designed to ride along the
hem edge.
Zipper Foot E
This foot can be snapped on either to the right
or to the left of the needle. This makes it easy
to sew on both sides of the zipper. Move needle
position to right or left to sew closer to zipper
teeth or for covering large cording (see page 2-7).
Presser Foot H
This foot, with a coating underneath, is used
when sewing foam, vinyl, plastic, or leather to
minimize the risk of these materials sticking to
the foot.
Edging Foot J
This foot is used for overcasting and seam/
overcasting, i.e. stitches which have a stitch
width of 5.0 and 5.5 mm. Stitches form over the
pin which prevents puckering at the edge of the
fabric.
1-18
Set it Up
: Always use the recommended presser foot
NOTE
supplied with the machine!
A
7
C
7
E
7
J
B
7
D
H
7