Embroidery Pop-Up Windows - Husqvarna Viking Designer SE User Manual

Embroidery Mode

Embroidery Pop-Up Windows

Embroidery unit must be attached
You must attach the embroidery unit before
starting to embroider.
Embroidery unit calibration
As the embroidery unit is connected to the
machine, a Pop-up prompts you to slide off the
hoop, and clear the machine area for positioning
of the embroidery arm. Touch to calibrate
the embroidery unit and to position the arm.
This menu also reminds you to snap on the R
foot for embroidery.
Delete selected
Your Designer SE will ask you to confi rm when
you have selected to delete all designs.
Attach correct hoop
When the size of the hoop on the machine does
not match the size displayed on the screen, your
Designer SE will not sew. Change the hoop to
the size displayed on the screen, or change the
setting for hoop size to match your selected
hoop, see page 4-5.
Design outside hoop area
You cannot start to embroider when any of the
designs are outside the hoop area. Move the
design, or change hoop size.
Check upper thread
Your Designer SE stops automatically if the
top thread runs out or breaks. Re-thread the
top thread, and touch . Touch to
continue.
Stopped to cut thread ends
Your Designer SE stops automatically a few
stitches after you begin embroidering each
color. Cut the starting thread tail, touch to
resume embroidering.
4-20