Table of Contents
Advertisement
Set to Embroider
Park Position / Easy Thread Trims
Remove the hoop and touch
to put the
embroidery unit in park position for easy storage
in the embroidery unit case.
When embroidering and changing from one
thread to another, it is best to cut the long
"jump" stitches. This will make the thread
trimming easier when the em broi dery is fi nished.
Touch
, the hoop moves towards you. Cut
the jump threads and touch
again. The
hoop moves back to its ready po si tion. Touch
to resume the embroidery.
in the Embroidery Color Control tab
has the same function (see page 4-8).
Speed
Each stitch type in a design has a pre-set
maximum speed at which it can be sewn. To
reduce the speed when using speciality threads,
touch
. To increase the speed again touch
.
Touch when not embroidering and a pop-up
will appear showing the set speed. You can
also set the speed by touching the slider in the
pop-up. The pop-up closes automatically three
seconds after the change has been made. You
can change the speed while embroidering, but
no pop up will appear.
Start and Stop Embroidering
Touch
to begin embroidering and touch
again to stop. Designer SE stops automatically
at color changes and when the embroidery is
fi nished.
Sensor Foot Up and Extra Lift
Touch
to lift pres ser foot to up po si tion.
Touch once more and the pres ser foot will raise
to ex tra lift, to make it easy to insert or remove
the hoop.
: See pages 1-16 and 1-17 for information on
NOTE
the function buttons in Sewing Mode.
3-8
Advertisement
Table of Contents
