Sewing Pop-Up Windows - Husqvarna Viking Designer SE User Manual

Sewing Pop-Up Windows

Designer SE features a number of pop-up
windows that appear on the screen to guide you
when your Designer SE stops or is not sewing.
Check upper thread
Your Designer SE stops automatically if the top
thread runs out or breaks. Re-thread the top
thread, touch . Touch
foot control to continue.
Bobbin empty
Your Designer SE stops when the bobbin is
almost empty. Replace the empty bobbin with a
full one. (Bobbin winding, see page 1-13)
: It is possible to continue sewing until all thread
NOTE
on the bobbin has run out. Just continue sewing
without closing the pop-up.
Presser foot too high
Your Designer SE will not sew if there is too
much fabric under the presser foot.
Remove sensor buttonhole foot
When the Sensor Buttonhole Foot is inserted
you can not select
• a stitch that is not a buttonhole,
• a buttonhole that cannot be sewn with the
Sensor Buttonhole Foot, or
• an adjusted buttonhole saved without the
Sensor Buttonhole Foot on the U-menu.
Remove the foot or select a buttonhole that can
be sewn with the Sensor Butonhole Foot.
Adjust white line to white area
When you insert the fabric for sewing a
buttonhole, the wheel of the Sensor Buttonhole
Foot might move. A pop-up prompts you to line
up the white area with the white line.
2-16
Sewing Mode
or step on the