Spool Pins - Husqvarna Viking Designer SE User Manual

Set it Up

Spool Pins

Your Designer SE has two spool pins, a main
spool pin and an auxiliary spool pin. The spool
pins are designed for all types of thread. The
main spool pin (a) is adjustable and can be used
a
in a horizontal position (the thread reels off the
stationary spool) or in a vertical position (the
b
thread spool rotates). Use the horizontal position
c
for normal threads and the vertical position for
large spools or specialty threads.
Horizontal Position
Fold the spool pin out towards the right. Place
the thread spool on the spool pin so that the
thread reels over the top. Slide on a spool holder
(see below) and then move the spool pin back to
the horizontal position.
small holder
There are two spool holders on the spool pin.
For narrow thread spools, the small holder (b)
is placed in front of the spool. For large thread
spools, the large holder (c) is placed in front of
the spool.
The fl at side of the spool holder should be
pressed fi rmly against the spool. There should be
large holder
no space between spool holder and thread spool.
Vertical Position
Pull the spool pin out towards you and turn to
the vertical position. Slide on the large spool
holder and place a felt pad under the thread
spool. This is to prevent the thread from reeling
off too fast.
: No spool holder should be placed on top of
NOTE
the spool as this prevents the spool from rotating.
1-10