Table of Contents
Advertisement
Care of the machine
To keep your sewing machine operating well,
clean it often. No lubrication (oiling) is needed.
Lower the feed teeth by touching
to extra lift. Turn off at the main power
switch.
Cleaning
Wipe the exterior surfaces of your Designer SE
with a soft cloth to remove any dust or lint built
up.
Wipe the Interactive Designer Screen with a soft
damp cloth.
Removing the Stitch Plate
Remove the presser foot and slide off the bob bin
cover. Place the stitch plate opener on the brush,
both found with the accessories. Place the stitch
plate opener in the re cess at the rear of the
stitch plate and turn. Clean the feed teeth with
the brush.
Cleaning under the Bobbin Area
After sewing several projects or any time you
notice an accumulation of lint in the bobbin case
area, bobbin area must be cleaned.
Remove the bobbin case holder (1) covering
the front part of the bobbin case (2). Remove
the bob bin case by lifting it up. Clean with the
brush. A small vacuum attachment works well to
remove dust and lint built up.
Put the bobbin case and the bobbin case holder
back in place.
Slide on the Stitch Plate
With feed teeth down, place the stitch plate
about 5 mm in front of the rear edge and push it
back. Slide on the bobbin cover.
6-2
Care of your Designer SE
10 15
1.
10 15
2.
Advertisement
Table of Contents
