Remove The Embroidery Unit; Hoop The Fabric - Husqvarna Viking Designer SE User Manual

Remove the Embroidery Unit

1. To store the embroidery unit in the embroidery
case, touch . The embroidery arm will
move to the park po si tion.
under the Embroidery Color Control
tab, , has the same function (see page
4- 8).
2. Press the button at the left under side of the
unit and slide the unit to the left to remove it.
3. Close the cover on the socket.

Hoop the Fabric

1. Loosen the screw on the larger outer hoop.
Remove the inner hoop. Place the hoop on a
fi rm fl at surface with the screw on the lower
right. There is a small arrow in the center of
the lower edge of the hoop which will line
up with a small arrow on the inner hoop.
2. Place stabilizer and the fabric on top of the
outer hoop and place the inner hoop on
top of the fabric with the small arrow at the
bottom edge.
3. Push the inner hoop fi rmly into the outer
hoop.
: Be sure to loosen the hoop screw enough for
NOTE
the fabric and stabilizer thickness so you can easily
push the inner hoop in place. Push in on the sides of
the large hoop to be sure both hoops are even.
4. Tighten the hoop screw. The fabric should
be taut in the hoop for the best results. Do
not pull on the fabric as this can stretch it
and distort your design. Use the Screw Grip
to tighten the hoop screw if needed. Do not
over tighten.
: Read more about Stabilizers and Hoops in the
NOTE
Accessory User's Guide.
3-4
Set to Embroider