Winding Specialty Threads; Bobbin Winding While Embroidering Or Sewing - Husqvarna Viking Designer SE User Manual

5. Push the bobbin winder lever towards
the bobbin to wind. A pop-up appears on
screen. To adjust winding speed drag the
arrow on the slider with your stylus. Stop
and start the bobbin winding with the on-
screen buttons.
When the bobbin is full, the bobbin winder
lever will switch back and the winding
will stop automatically. The pop-up closes.
Remove the bobbin and cut the thread using
the bobbin thread cutter (c).

Winding Specialty Threads

We do not recommend winding speciality
threads such as "invisible" or other stretchy
threads, metallic or fl at metallic threads through
the needle.
Always wind these threads at minimum speed.
1. Place an empty bobbin on the bobbin
spindle at the front of the machine (the
markafacing up). Use only the original
Husqvarna Viking green bobbins.
2. Place the large spool holder and a felt pad
under the spool on the main spool pin set in
the vertical position.
3. Bring the thread over the pre-tension thread
guide and down around the thread tension
disc (a), then through thread guide (b) as
illustrated.
4. From above, wind a few turns of thread
clockwise around the bobbin and into the
thread cutter (c).
5. See top of page (Bobbin Winding, step 5).
Bobbin Winding while
Embroidering or Sewing
Your Designer SE has a separate motor for
bobbin winding to wind bobbins while
embroidering or sewing.
Place the spool on the auxiliary spool pin and
thread the machine for bobbin winding same as
above except the thread does not go over the
pre-tension thread guide.
: The main spool pin must be in horizontal
NOTE
position to wind from the auxiliary spool pin.
1-14
Set it Up
: Do not lower the winding speed too much
NOTE
when winding through the needle. The resistance
will be too high and Designer SE cannot wind.
a
: Regular threads can also be wound this way or
NOTE
with the spool pin in horizontal position.
a
: Depending on the type of thread, wrap the
NOTE
thread one or two turns around the bobbin thread
tension disc (a) to put more tension on the thread.
Embroidery weight bobbin thread should be taken
two turns around the thread tension guide.
c
b