Table of Contents
Advertisement
Embroidery Mode
Bobbin empty
Your Designer SE stops when the bobbin
is almost empty. Replace the empty bobbin
with a full one, touch
. Pull back excess
top thread. Step backwards a few stitches by
touching − in
. Touch
to
resume the embroidery.
: When changing the bobbin, touch
above
NOTE
the needle or
in the Embroidery Color Control
Tab and the hoop will move away for easy access
to the bobbin case. Once the bobbin is replaced
touch button again to move the hoop back to where
the embroidery stopped. Touch
to resume the
embroidery.
Stopped for color change
Your Designer SE stops automatically and the top
thread is cut. Remove the spool and rethread with
the recommended color displayed in the color
menu on screen or in the Embroidery Booklet.
Touch
to resume embroidering.
Stop command in design
Designer SE stops automatically for you to
trim the fabric on cut work, applique etc. See
explanation for each design in the Embroidery
Booklet, or look in your Designer SE Handbook
for general instructions for different techniques.
Embroidery is fi nished
When the embroidery is fi nished Designer SE
alerts you and asks if you want to clear the
screen. Touch
to remove the design from
the screen, or touch
to get back to your
embroidery with the possibility to save it.
Replace fi le?
The fi rst time you try to save a design with the
same name as a design fi le that already exists,
your Designer SE will prompt you to confi rm
this. If you keep working on the same design
and save again, Designer SE will not ask again.
4-21
Advertisement
Table of Contents
