Gateway 9510 User Manual page 90

14
Connect the power cables to chassis components and the system board. See
board" on page 7
Route the P1, P2, and P14 cables to the system board and connect to the
■
appropriate connectors.
Route the longest power cables (P8, P9, P10, and P11) to the six-drive hot-swap
■
drive bay and connect one cable to the drive back plane.
Route the shorter power cables (P3, P4, and P5) to the upper drive bay and
■
connect to any installed devices.
To system board
15
Follow the instructions in
16
Reinstall the power supply module(s) by following the instructions in
power supply module" on page
17
Follow the instructions in
18
Connect power to the server and restart.
for connector locations on the system board.
To upper drive bay
"Installing the air ducts" on page
81.
"Closing the server case" on page
www.gateway.com
Replacing a power distribution module
To 4-drive
To 6-drive bay
47.
52.
"System
bay
"Replacing a
85