Additional Beep Codes Provided By Optional Intel Management Modules; Led Information - Gateway 9510 User Manual

Chapter 7: Troubleshooting
Additional beep codes provided by optional Intel
Management Modules
In addition to the beep codes above, the following additional beep codes are provided if
an Intel Management Module is installed:
Beep Codes
1
1-5-1-1
1-5-2-1
1-5-2-3
1-5-2-4
1-5-4-2
1-5-4-3
1-5-4-4

LED information

The system board in this server includes LEDs that can assist you in troubleshooting your
system. See the following table for a description of these LEDs and the information they
provide:
LED Name Function
ID Aid in server
identification
from the back
panel
System Fault Visible fault
warning
IDE Activity Front panel
152
Description
Control panel CMOS clear has been initiated
Processor failure. Reseat or replace the failed processor.
No processor is installed or the CPU 1 socket is empty. Reseat or
replace the failed processor.
Processor configuration error or CPU 1 socket is empty. Reseat or
replace the failed processor. In a two-processor system, make sure
the processors are identical.
Front-side bus select configuration error.
DC power unexpectedly lost.
Chipset control failure.
Power control failure.
Location
Front panel and
left back of
system board
Front panel and
left back of
system board
Front panel and
left side of
system board
www.gateway.com
Color Description
Blue On = Server identification
enabled
Green or On = No fault
■
Orange Green blink = Degraded
■
Orange = Critical error or
■
non-recoverable
Orange blink = Non critical
■
Green Blinking = Drive active