Gateway 9510 User Manual page 108

Caution
3
Remove the jumper across pins 9-10 of jumper J1D1, then place the jumper across
pins 10-11.
4
Follow the instructions in
5
Insert a DOS-bootable USB disk-on-key containing a valid BIOS image into a USB port
or a DOS-bootable CD into the CD drive.
Important
6
Reconnect the power cords and turn on the server. The BIOS recovery is initiated.
While the BIOS is being recovered, the monitor displays a blue screen and the server
will beep continually. The process is complete when the server stops beeping.
7
Remove the bootable USB disk-on-key or CD.
Moving the jumper while the power is on can damage your server.
Always turn off the server and unplug the power cords and all other
cables before changing the jumper.
J1D1 CMOS
CLEAR
1
BMC Control
2
Force Erase
3
PASSWORD
CLEAR
5
Protect
6
Erase
7
RECOVERY
BOOT
9
Normal Boot
10
Recovery Boot
11
"Closing the server case" on page
The new flash BIOS image will not fit on a diskette.
www.gateway.com
Updating the BIOS
52.
103