Printing Area
Printing Area and Margins
Trailing edge of media
Media clamp
A
B
Left mar-
gin (*1)
Front edge of media
A: Setting of the [SIDE MARGIN] menu item (5 mm (3/16 inch), 10mm (6/16 inch) (default setting), or 25 mm
(16/16 inch))
B: Width clamped by the media clamp (approx. 5 mm (3/16 inch))
*1 The amount of the left and right margins is the total of A and B. In the following cases, however, the setting
for A becomes the amount of margin without change.
When media has been loaded without installing the media clamps
When the [SHEET TYPE] menu item is set to [CLEAR] (regardless of whether the media clamps are pres-
ent)
*2 The amount of right margin can be changed by using
*3 75 mm (3 inches) is the value for when "SHEET SETUP" is set to "ROLL."
When "RIGID" is selected, this value becomes the value specified for "FRONT MARGIN." When the media
hold down bar is used, about 200 mm (7.9 inches) of space is needed.
8
166
140 mm (5.5 in.)
Printing Area
75 mm
(3 in.) (*3)
.
Media
Media clamp
A
B
Right mar-
gin (*1) (*2)