Use Conditions of the Media Take-up System
When Performing Output without Pullback Movement (or When [TU] Is Selected)
SETUP SHEET
TU
Never pull the media with excessive force.
If the media is pulled forcedly, it may result in interruptions during output or inaccuracy of output locations.
When using the media take-up system, to avoid pulling media with undue force, be sure to observe the fol-
lowing points.
Never operate the MANUAL switch for the take-up unit when the loading lever is pulled back.
Never press
When the computer has an activated setting to pull back the media after output, disable it.
Set 50mm (2.0 inches) or more on the computer for the margin from the output end location to the next
output start location (or the space between the pages).
Do not perform pullback printing.
When performing continuous printing of two or more pages
When you're performing continuous printing and take-up for two or more pages, give attention to the fol-
lowing points.
If the setting to execute automatic cutoff of the media can be made on the computer, then turn this setting
off. Making the setting on the computer to execute automatic cutoff of the media results in media cutoff
after each page is printed. Take up quits as soon as the media is cut off.
In using the media take-up system to perform output without pullback move-
ment, select [TU] of the [SETUP SHEET] menu.
When [TU] is selected, follow the below instructions.
to pull the media back.
3
77