An Error Message Appears - Roland VersaUV LEJ-640 User Manual

An Error Message Appears

This describes the error messages that may appear on the machine's display, and how to take
action to remedy the problem. If the action described here does not correct the problem, or if an
error message not described here appears, contact your authorized Roland DG Corp. dealer .
[TURN POWER OFF AND SET INK MODE]
The sub power is turned on with the ink mode unset.
Turn off the sub power. Select the ink mode, and then turn on the sub power.
 "Setup Guide"
[CAN'T PRINT CROP CONTINUE?]
The size of the data including the crop marks is larger than the printing or cutting area of
the loaded media.
To continue performing output without correcting this, press . At this time, the portion extending
beyond the printing or cutting area and the crop marks are not output. To stop output, stop sending data
from the computer, then raise the loading lever. Make the printing or cutting area wider, such as by replacing
the media with a larger piece of media or by changing the positions of the pinch rollers, then send the data
again.
The size of the data being output is too small.
Make the scanning-direction (movement direction of print heads) size of the data at least 65 mm (2.6 in). To
continue performing output without correcting this, press . At this time, the data is output without
printing the crop marks. To stop output, stop sending data from the computer, then hold down for
one second or longer. Change the size of the data, then send the data again. There is no limitation in the size
of the data in the media-feed direction.
[TEMPERATURE IS TOO HIGH **°C]
The temperature of the location where the machine is installed has risen above the ambient
temperature at which the machine can operate.
Operation cannot be continued. Switch off the sub power. The displayed temperature is the current ambient
temperature of the installation location. Bring the installed location to a temperature at which operation is
possible (20 to 32°C) and allow the machine to come to room temperature, then turn on the power.
[SERVICE CALL xxxx]
An unrecoverable error occurred, or part replacement that must be performed by a service
technician is required.
Note the number displayed, then switch off the sub power. After you switch off the power, inform your autho-
rized Roland DG Corp. dealer of the number that appeared on the display screen.
7
162